Wet carpet should be dealt with quickly to keep your carpet intact and to avoid problems with mold and mildew.
What happens if your carpet gets wet.
In unfortunate instances you may also experience flooding a plumbing malfunction or an issue with a diy carpet cleaning machine that could create a soaking wet carpet.
Be more careful next time.
Vacuum the carpets thoroughly and then hang them somewhere to dry.
Go over the damp carpeting multiple times in slow straight lines.
The tools are simple.
If it s only partially flooded move everything over to the dry side.
For those with children and pets small spills can happen often.
At this point the two things the glue was holding together begin to separate and allows an area for mold to begin growing.
Then it s time to extract the water from the carpet.
Remove the battery pack.
Make sure your hands are dry and plug in the wet dry vacuum.
Wet vacs are the perfect tool for.
Follow these steps for drying your carpet properly and preventing the spread of moisture and mildew.
The easiest way to get the moisture or water out of your carpet is by removing it with a wet vacuum.
We highly suggest you do this to prevent mold and mildew pulling your carpet out isn t hard and will help you find any areas where water is pooling.
The sun s uv rays will also kill some of the.
Remove the brushes and filter.
Don t waste your time trying to dry out the carpet with a wet dry shop vacuum it simply doesn t have enough power.
Instead rent an extractor if available or carpet cleaner an air mover fan or two and a large commercial dehumidifier.
Fans bleach and cleaners.
Pull the carpets depending on how wet things are you may need to pull the carpets.
Gather up all the towels you can spare and begin soaking up the excess moisture.
Set it to dry and move it around the wet carpeting.
The sooner you start cleaning up after water damage the sooner you can stop mold from growing under your carpet.
Clean and dry everything.
If you can get the furniture to another room or a garage try that method.
If your roomba happens to hit a wet spot on your floor this is what you should do.
Spread towels over the wet carpet.
The most important part is first stopping water from flowing into the problem area.
Red cross officials say many homeowners can get rid of the mold just fine after a flood but it will require a bit of elbow grease.
When carpet gets wet and is left wet it can cause problems like delamination that happens when there is excessive moisture which weakens the glue.
It is best to clear out the entire room if the carpet is completely flooded.
Rent the largest dehumidifier available.
After thoroughly drying with a cloth let it air dry for a few hours then reassemble it and try to charge it.